Several heads that only rise halfway can indicate a shared pressure or flow problem. Do not assume every rotor has failed. Hunter identifies broken zone pipes, worn riser seals and restricted valve opening as causes to investigate.
Sprinkler Master Repair (South Valley) • South Salt Lake County, UT
Call (801) 988-9671Rotor repair service · Back to the FAQ hub · Jump to the diagnostic diagram
Use the failed-head pattern
Tell us whether one rotor, the last few heads or the entire zone stays low. Note any new wet patch and whether the problem started after fence work, planting or excavation. Stop running the zone if water is escaping and causing damage.
Match the repair to the cause
- Broken zone pipe: repair the pipe leak.
- Water escaping past worn seals: check seal compatibility and replace the worn components.
- A valve that does not fully open: inspect the valve and address the restriction.
These repair paths come from Hunter’s partial-pop-up checklist. A new head will not fix a pipe break elsewhere in the zone.
Why a new rotor may behave like the old one
If the same symptom remains after replacement, return to the zone diagnosis. Compare its operation with the other stations and have operating conditions checked before replacing more parts. Read our low-pressure troubleshooting page.
About the video below
The seal-replacement demonstration is relevant only when a worn seal has been identified. It is not a complete test for every cause of heads staying down.

Manufacturer video
Hunter: Replacing a Rotor Riser Seal. Use the instructions for your exact model.
Watch on YouTube. Video by Hunter Landscape Irrigation.
Where to buy rotors, nozzles and repair parts locally
These are independent retailers, not Sprinkler Master service locations. Call the store to confirm current hours, stock and return terms before visiting.
- Sprinkler Supply Company — West Jordan
7878 S 1410 W, West Jordan, UT 84088. Official store directory. - Sprinkler Supply Company — Riverton
11654 S Redwood Rd, Riverton, UT 84095. Official store directory. - Sprinkler World — Sandy
Official Sandy store listing. Confirm the location and parts availability directly.
Bring the rotor model and nozzle information
Photograph the rotor cap, model label and readable nozzle number. Note the distance to neighboring heads and whether the head waters a corner, half circle or full circle. Ask the supplier to confirm compatible parts rather than choosing by color alone.
Supplier listings checked October 6, 2026. Specific fitting and repair-kit stock has not been confirmed.
What to tell us when you call
Tell us which zone is affected, whether one head or several have the problem, and whether it happens while watering or after shutoff. A photo of the head and its model label can help us identify the parts. Call (801) 988-9671 to discuss the problem and scheduling; ask about visit charges and repair approval before work begins.
Outside this service area? The Sprinkler Master location directory lists other locations with their own contact details.
Towns and communities we serve
Explore our local service pages below. Call (801) 988-9671 to confirm availability for your address.
- Cottonwood Heights, UT
- Bluffdale UT
- Draper Utah
- Herriman UT
- Holladay UT
- Kearns UT
- Magna UT
- Midvale, UT
- Millcreek UT
- Murray UT
- Riverton UT
- Sandy Utah
- South Jordan Utah
- Taylorsville UT
- West Jordan Utah
- West Valley City UT
- White City Utah
Outside Salt Lake County? Our Tooele service page has information for that area; call to confirm coverage and travel arrangements.
Heads rise only partway
- One head or several? Record the pattern.
- Inspect for pipe leaks, excessive leakage past seals and valve restrictions.
- Repair the identified fault, then check the zone again before replacing more heads.
Use this sequence with the manufacturer instructions cited above. Stop the zone before opening a head.
